Cisco Broadband Cable Command Reference Guide

Chapter 2 Cisco Cable Modem Termination System Commands
Related Commands
OL-1581-05
20480K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0
Table 2-46 describes significant fields shown in these displays.
Table 2-46 show version Field Descriptions
Field Description
IOS (tm) 7200 Software
(UBR7200-P-M), Version xx.x
Always specify the complete version number
when reporting a possible software problem. In the
example, the version number is Cisco IOS Release
12.1(10)EC.
ROM: System Bootstrap Bootstrap version string.
Router uptime is The amount of time the system has been up and
running.
System restarted at Also displayed is a log of how the system was last
booted, as a result of normal system startup or
system error.
System image file is If the software was booted over the network, the
Internet address of the boot host is shown. If the
software was loaded from onboard ROM, this line
reads “running default software.”
cisco uBR7246VXR (NPE300)
processor
The remaining output in each display shows the
hardware configuration and any nonstandard
software options.
Configuration register is The configuration register contents, displayed in
hexadecimal notation.
Cisco Broadband Cable Command Reference Guide
show version
The output of the show version command can also provide certain messages, such as bus error messages.
If such error messages appear, report the complete text of this message to your technical support
specialist.
Tip In Cisco IOS Release 12.1(12)EC, 12.2(8)BC1, and later releases, you can add a timestamp to show
commands using the exec prompt timestamp command in line configuration mode.
Command Description
show diag Displays diagnostic information for the cable interface line cards.
2-477