Cisco Broadband Cable Command Reference Guide

Chapter 2 Cisco Cable Modem Termination System Commands
show interface cable qos paramset
Syntax Description
OL-1581-05
show interface cable qos paramset
To display the attributes of the service flow QoS parameter set, use the show interface cable qos
paramset command in privileged EXEC mode.
show interface cable {slot/port | slot/subslot/port} qos paramset [paramset-index] [verbose]
Note Parameter sets that contain a service-class name string are in an “unexpanded” state and serve as
provisioning envelopes of class-based service flows. The actual attributes of such parameter sets depend
on the service class that is referenced at the time the parameter sets are expanded.
Command Modes Privileged EXEC
Command History
slot/port Identifies the cable interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0
or 1, depending on the cable interface.
slot/subslot/port Identifies the cable interface on the Cisco uBR10012 router. The following
are the valid values:
slot = 5 to 8
subslot = 0 or 1
paramset-index
port = 0 to 4 (depending on the cable interface)
Identifies the desired service template index (1 to 255).
verbose Displays full details about the QoS parameter set.
Release Modification
12.1(4)CX This command replaces the show cable qos profile command for
DOCSIS 1.1 operation.
12.2(4)BC1 Support was added to the Release 12.2 BC train.
Examples The following sample output shows the standard and verbose formats of the show interface cable qos
paramset command:
Router# show interface c6/0 qos paramset
Index Name Dir Sched Prio MaxSusRate MaxBurst MinRsvRate
1 US BE 0 64000 0 0
2 DS BE 0 1000000 0 0
3 US BE 7 2000000 1522 100000
4 DS BE 0 4000000 1522 0
Router# show interface c6/0 qos paramset 1 verbose
Cisco Broadband Cable Command Reference Guide
2-445