27.03.2013 Views

Cisco Broadband Cable Command Reference Guide

Cisco Broadband Cable Command Reference Guide

Cisco Broadband Cable Command Reference Guide

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Chapter 2 <strong>Cisco</strong> <strong>Cable</strong> Modem Termination System <strong>Command</strong>s<br />

OL-1581-05<br />

Active QoS Timeout 30 seconds<br />

Maximum Concatenated Burst: 1522 bytes<br />

Scheduling Type: Realtime Polling Service<br />

Request/Transmission Policy: 0x1FF<br />

Nominal Polling Interval: 10000 usecs<br />

Tolerated Poll Jitter: 4000 usecs<br />

IP ToS Overwrite [AND-mask,OR-mask]: 0xE0,0xA0<br />

Max Latency: 0 usecs<br />

Parameter Presence Bitfield: {0xDC8, 0x83E000}<br />

Index: 4<br />

Name: UP_BE<br />

Direction: Upstream/Downstream<br />

Traffic Priority: 5<br />

Maximum Sustained Rate: 128000 bits/sec<br />

Max Burst: 2000 bytes<br />

Minimum Reserved Rate: 0 bits/sec<br />

Minimum Packet Size 64 bytes<br />

Admitted QoS Timeout 30 seconds<br />

Active QoS Timeout 30 seconds<br />

Maximum Concatenated Burst: 1522 bytes<br />

Scheduling Type: Best Effort<br />

Request/Transmission Policy: 0x0<br />

IP ToS Overwrite [AND-mask,OR-mask]: 0xE0,0x0<br />

Max Latency: 0 usecs<br />

Parameter Presence Bitfield: {0xDE8, 0x80E000}<br />

Index: 5<br />

Name: DOWN_BE<br />

Direction: Upstream/Downstream<br />

Traffic Priority: 5<br />

Maximum Sustained Rate: 1000000 bits/sec<br />

Max Burst: 3000 bytes<br />

Minimum Reserved Rate: 0 bits/sec<br />

Minimum Packet Size 64 bytes<br />

Admitted QoS Timeout 30 seconds<br />

Active QoS Timeout 30 seconds<br />

Maximum Concatenated Burst: 0 bytes<br />

Scheduling Type: Best Effort<br />

Request/Transmission Policy: 0x0<br />

IP ToS Overwrite [AND-mask,OR-mask]: 0xFF,0x0<br />

Max Latency: 0 usecs<br />

Parameter Presence Bitfield: {0xDE8, 0x0}<br />

Router#<br />

show cable service-class<br />

Tip In <strong>Cisco</strong> IOS Release 12.1(12)EC, 12.2(8)BC1, and later releases, you can add a timestamp to show<br />

commands using the exec prompt timestamp command in line configuration mode.<br />

Related <strong>Command</strong>s cable service class Defines and modifies a service class.<br />

show interface cable<br />

qos paramset<br />

Displays the parameters in one or more service templates.<br />

<strong>Cisco</strong> <strong>Broadband</strong> <strong>Cable</strong> <strong>Command</strong> <strong>Reference</strong> <strong>Guide</strong><br />

2-393

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!