Cisco Broadband Cable Command Reference Guide

Chapter 2 Cisco Cable Modem Termination System Commands
OL-1581-05
Cisco Broadband Cable Command Reference Guide
hccp channel-switch
Defaults The CMTS is not configured to use an RF switch, and no cable interfaces are configured for N+1
redundancy.
Command Modes Interface configuration (cable interface only)
Command History
vty (Optional) Specifies that a Virtual Terminal connection (Telnet connection)
is being used to control the Quintech RF switch.
line-number Specifies the line number on which the Quintech RF switch is receiving
control information for this CMTS. The valid range is 0 to 17 for the default
serial port, 0 for the aux port, 0 for the console port, and 0 to 99 for the vty
port.
port Specifies the port number being used on the Quintech RF switch. The valid
range is 1 to 255.
wavecom-hd Specifies that this is the configuration for a Wavecom HD4040 and
QHD4040 upconverter.
wavecom-ma Specifies that this is the configuration for a Wavecom DUAL4040D,
MA4040D, or UC4040D upconverter.
prot-ip-address Specifies the IP address for the upconverter used for the Protect interface
used for this cable interface.
protect-module Specifies the module number on the upconverter used for the Protect
interface to be used for this cable interface. The valid range is 1 to 255.
work-ip-address Specifies the IP address for the upconverter used for the Working interface
used for this cable interface.
work-module Specifies the module number on the upconverter used for the Working
interface to be used for this cable interface. The valid range is 1 to 255.
Release Modification
12.2(4)XF1,
12.2(4)BC1
This command was introduced for the Cisco uBR10012 router, replacing
the hccp ds-switch command for use with the Cisco uBR-RFSW N+1
RF Switch.
12.2(8)BC2 Support was added for the Cisco uBR-LCP-MC16C,
Cisco uBR-LCP-MC16E, and Cisco uBR-LCP-MC16S cards on the
Cisco uBR10012 router.
12.2(11)BC1 Support was added for the Cisco uBR7246VXR router and
Cisco uBR-MC16C, Cisco uBR-MC16S, and Cisco uBR-MC28C cards.
Usage Guidelines You must configure each Working and Protect cable interface for use with the Cisco uBR-RFSW N+1
RF Switch, typically specifying one hccp channel-switch command to configure the RF switch
information, and another hccp channel-switch command to configure the upconverter.
The Protect interface is configured with the same hccp channel-switch commands as those that are used
on the Working interface. However, typically, the same Protect interface is configured with multiple
hccp channel-switch commands to protect multiple Working interfaces.
2-291