Cisco Broadband Cable Command Reference Guide

hccp reverttime
hccp reverttime
Syntax Description
Defaults 30 minutes
2-304
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To specify the amount of time a Protect interface waits before automatically reverting back to a Working
interface following a system failover, use the hccp reverttime command in cable interface configuration
mode on the Working CMTS. To set the revert-time back to its default value, use the no form of this
command.
hccp group reverttime revert-time
no hccp group reverttime
Command Modes Interface configuration (cable interface only, on the Working CMTS)
Command History
group The group number for the specified interface. Valid values are any number
from 1 to 255, inclusive.
revert-time The amount of time (in minutes) that a Protect interface waits before
automatically switching back to a Working interface following a system
failover. The allowable range is 1 to 65,535 minutes, with a default of 30
minutes.
Release Modification
12.1(3a)EC This command was introduced for the Cisco uBR7200 series routers.
12.1(7)EC1 Support was added for the Cisco uBR-MC16S cable interface line card.
12.2(4)XF1,
Support was added for the N+1 RF Switch with the Cisco uBR10012 router
12.2(4)BC1
and Cisco uBR-LCP-MC28C card.
12.2(8)BC2 Support was added for the N+1 RF Switch with the Cisco uBR10012 router
and Cisco uBR-LCP-MC16C, Cisco uBR-LCP-MC16E, and
Cisco uBR-LCP-MC16S cards.
12.2(11)BC1 Support was added for the N+1 RF Switch with the Cisco uBR7246VXR
router and Cisco uBR-MC16C, Cisco uBR-MC16S, and
Cisco uBR-MC28C cards.
Usage Guidelines Use this command to configure the revert-time on the cable interfaces on the Working CMTS so that the
Working CMTS will automatically resume normal operations and the Protect CMTS will automatically
resume normal protect operations, in case an operator forgets to manually switch the Working CMTS
back into operation after fixing the original problem.
The Working CMTS first counts down two minutes of suspend time before starting to count down the
revert-time. Any failures that occur within this two-minute suspend time are considered part of the same
failure.
OL-1581-05