Cisco Broadband Cable Command Reference Guide

OL-1581-05
Cable CPE Commands
CHAPTER
Cisco Broadband Cable Command Reference Guide
5
This section describes the cable-specific commands available to the family of Cisco cable customer
premises equipment (CPE) devices. See the following sections for more information:
Supported Platforms and Cisco IOS Releases—Describes the cable CPE platforms and Cisco IOS
releases that support the commands listed in this section.
Cable CPE Commands—Describes each cable-specific command to change or display the
configuration of a cable CPE device.
Debug Commands—Describes the cable-specific commands that are needed only when
troubleshooting a cable CPE device and its configuration.
Supported Platforms and Cisco IOS Releases
Table 5-1 lists the Cisco cable CPE platforms and Cisco IOS releases that support the commands listed
in this section. Earlier Cisco IOS software releases might not support all the commands listed, or might
support them on fewer platforms or with a limited functionality. See the “Command History” section of
each command for complete details.
Table 5-1 Cisco Cable CPE Platforms
Platform Cisco IOS Release
Cisco CVA122 Cable Voice Adapter Release 12.2(4)T, 12.2(8)YI, and later
Cisco uBR904 cable access router Release 12.1(17) 1
Cisco uBR905 cable access router Release 12.2(4)T, 12.2(8)YI, and later
Cisco uBR924 cable access router Release 12.2(11) 1
Cisco uBR925 cable access router Release 12.2(2)XA, 12.2(4)T, 12.2(8)YI, and later
1. The Cisco uBR904 and Cisco uBR924 cable access routers have reached their end-of-life. These routers are being maintained
in their respective mainline trains but are not being updated with any new features.
Note Not all platforms support all commands, and support for some commands depends on the specific
Cisco IOS release. See the “Command History” section for each command for a list of the supported
platforms and required Cisco IOS releases.
5-1