Cisco Broadband Cable Command Reference Guide

debug checkpoint
debug checkpoint
Syntax Description
Command Modes Privileged EXEC
Command History
4-74
Cisco Broadband Cable Command Reference Guide
Chapter 4 Cisco Cable Modem Termination System Debugging Commands
To enable debugging of the Checkpointing Facility (CF) subsystem on the Cisco uBR10012 router, use
the debug checkpoint command in privileged EXEC mode. To disable debugging output, use the no
form of the command.
debug checkpoint [all | errors | messages | temporary | timers]
no debug checkpoint [all | errors | messages | temporary | timers]
Usage Guidelines The debug checkpoint command enables debugging of the Checkpoint Facility (CF) subsystem, which
passes messages from the Active processor to the Standby processor. It also handles sequencing and
throttling, as needed, during redundancy operations.
Examples The following example shows how to enable debugging messages for the CF subsystem:
Related Commands
all (Optional) Enables all checkpoint debugging types.
errors (Optional) Enables debugging of any checkpoint errors that occur.
messages (Optional) Enables debugging for the messages that are sent during
checkpoint operations.
temporary (Optional) Enables basic checkpoint debugging (default).
timers (Optioanl) Enables debugging of the checkpoint timers.
Release Modification
12.2(11)BC3 This command was introduced for the Cisco uBR10012 universal
broadband router.
Router# debug checkpoint
Router#
Command Description
debug cable interface Enables debugging on a specific cable interface.
debug cable
Enables debugging for a specific CM, as identified by its hardware (MAC)
mac-address
address.
OL-1581-05