Cisco Broadband Cable Command Reference Guide

A
access-denied command
access lists
2-14
binding to a cable interface 2-93
configuring for a CM or CPE device 2-37
configuring for a host 2-75
specifying an access group for CMs 2-95
specifying encrypted multicast streams 2-93
Address Resolution Protocol, see ARP 4-6
admission control, specifying for the upstream 2-204
APS
ARP
3-5
activating for cable interfaces 2-16
debugging 4-6
enabling proxy ARP 2-125
associate command 3-5
Automatic Protection Switching 3-5
auto-sync command 3-7
B
Baseline Privacy Interface
adding a certificate to the hotlist 2-119
configuring certificate information 2-117
debugging command 4-7
debugging TEK and KEK key management 4-32
displaying 2-384, 2-443
enabling and configuring 2-115
enabling and configuring through the DOCSIS
configuration file 2-339
setting the KEK values 2-121
setting the TEK values 2-123
OL-1581-05
blind frequency hopping 2-224
BPI, see Baseline Privacy Interface
broadcast
echoing IP packets on an upstream 2-81
setting the UDP DCHP server address
bundling
2-73
configuring 2-18
displaying configuration 2-343
C
Cisco Broadband Cable Command Reference Guide
INDEX
cable arp command 2-16
cable bundle command 2-18
cable clock clear-counters command 2-20
cable clock force command 2-22
cable clock source-midplane command 2-24
cable cmcpe valid-time command 2-26
cable config-file command 2-28
cable dci-response command 2-31
cable dci-upstream-disable command 2-33
cable default-phy-burst command 2-35
cable device command 2-37
cable dhcp-giaddr command 2-39
cable downstream annex command 2-41
cable downstream channel-id command 2-43
cable downstream frequency command 2-44
cable downstream if-output command 2-46
cable downstream interleave-depth command 2-48
cable downstream modulation command 2-50
cable downstream override command 2-51
cable downstream rate-limit command 2-52
cable downstream rf-power command 2-55
cable downstream rf-shutdown command 2-57
IN-1