Cisco Broadband Cable Command Reference Guide

Chapter 2 Cisco Cable Modem Termination System Commands
show interface cable monitor
Syntax Description
Command Modes Privileged EXEC
Command History
OL-1581-05
show interface cable monitor
To display cable monitor information, use the show interface cable monitor command in privileged
EXEC mode.
show interface cable {slot/port | slot/subslot/port} monitor
slot/port Identifies the cable interface and downstream port on the Cisco uBR7100 series
and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0 or 1,
depending on the cable interface.
slot/subslot/port Identifies the cable interface on the Cisco uBR10012 router. The following are
the valid values:
slot = 5 to 8
subslot = 0 or 1
Examples The following is sample output from the show interface cable monitor command:
CMTS01# show interface cable 5/0 monitor
port = 0 to 4 (depending on the cable interface)
Release Modification
12.1(3a)EC This command was introduced.
12.2(4)XF Support was added for the Cisco uBR10012 universal broadband router.
12.2(4)BC1 Support was added to the Release 12.2 BC train.
US/ Time Outbound Flow Flow Type Flow Packet MAC MAC Encap
DS Stmp Interface Type Identifier Extn. Type Extn. Type Type
us no Et1/2 us-port 0 yes data no - docsis
all no Et1/2 acc-list 103 yes data no - docsis
all yes Et1/2 mac-addr 0050.0000.0000 yes mac no - -
Table 2-38 show interface cable monitor Field Descriptions
Field Description
DS Downstream. Indicates that only downstream flows are monitored.
UP Upstream. Indicates that only upstream flows are monitored.
ALL Indicates that all flows are monitored.
Cisco Broadband Cable Command Reference Guide
2-441