Cisco Broadband Cable Command Reference Guide

cable upstream shutdown
cable upstream shutdown
Syntax Description
2-244
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To disable a single upstream port, use the cable upstream shutdown command in cable interface
configuration mode. To enable the upstream port, use the no form of this command.
cable upstream n shutdown
no cable upstream n shutdown
Defaults Upstream port enabled
Command Modes Interface configuration (cable interface only)
Command History
Usage Guidelines The cable upstream shutdown command shuts down a single upstream port without affecting any of
the other upstream or downstream ports on the cable interface. To shut down the entire interface, use the
shutdown command in cable interface configuration mode.
Examples The following example shows how to disable the upstream port:
Related Commands
n Specifies the upstream port number. Valid values start with 0 for the first
upstream port on the cable interface line card.
Release Modification
11.3 XA This command was introduced.
router(config-if)# cable upstream 0 shutdown
Command Description
shutdown Shuts down (disables) an interface and all of its ports.
OL-1581-05