Cisco Broadband Cable Command Reference Guide

Chapter 4 Cisco Cable Modem Termination System Debugging Commands
debug hccp channel-switch
OL-1581-05
debug hccp channel-switch
To display debug messages related to an RF or channel switch that is being used for HCCP N+1
redundancy, use the debug hccp channel-switch command in privileged EXEC mode. To disable the
debug message output, use the no form of this command.
debug hccp channel-switch
no debug hccp channel-switch
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Release Modification
12.2(4)XF1,
12.2(4)BC1
Usage Guidelines The debug hccp channel-switch command displays debugging messages related to the SNMP messages
and other communication between the CMTS and an RF-switch or channel-switch during N+1 HCCP
operations.
Note You must use the debug hccp events command to activate HCCP event debugging before the debug
hccp channel-switch command will generate any debug output.
Examples The following example shows typical output for the debug hccp channel-switch command:
Router# debug hccp events
Router# debug hccp channel-switch
HCCP channel action debugging is on
This command was introduced for the N+1 RF Switch with the
Cisco uBR10012 router.
12.2(11)BC1 Support was added for the N+1 RF Switch with the Cisco uBR7246VXR
router.
Mar 7 10:11:55:HCCP: snmp response error from 1.8.26.100.
Mar 7 10:12:16:HCCP: snmp response error from 1.8.26.100.
Mar 7 10:13:23:HCCP_SNMP: unknown Wavecom snmp type
Mar 7 10:12:21:HCCP: failed to make community
Mar 7 10:12:21:HCCP: failed to create snmp message
Mar 7 10:12:21:HCCP: SPrintVarBind() failed
Mar 7 10:12:21:HCCP: snmp request failed
Mar 7 10:12:21:HCCP: snmp request cancelled
Mar 7 11:51:50:HCCP: group 1 member 1 Working is loading config
Mar 7 11:51:52:HCCP: group 1 member 1 Working finished loading config
Cisco Broadband Cable Command Reference Guide
4-83