Cisco Broadband Cable Command Reference Guide

Chapter 4 Cisco Cable Modem Termination System Debugging Commands
debug cable config-file
OL-1581-05
Cisco Broadband Cable Command Reference Guide
debug cable config-file
To display information about the DOCSIS configuration files that are generated by the internal DOCSIS
configuration file editor, use the debug cable config-file command in Privileged EXEC mode. To disable
debugging output, use the no form of this command.
debug cable config-file
no debug cable config-file
Syntax Description This command has no arguments or keywords.
Defaults No default behavior or values.
Command Modes Privileged EXEC
Command History
Release Modification
12.1(2)EC This command was introduced for Cisco uBR7200 series routers.
12.1(5)EC Support for this command was added for the Cisco uBR7100 series
routers.
12.2(4)BC1 Support was added to the Release 12.2 BC train.
12.2(11)BC2 Support for this command was added to the Release 12.2 BC train.
Usage Guidelines This command shows debugging messages about the internal configuration file editor on the Cisco
CMTS. For more information about the internal configuration file editor, see the cable config-file
command and its subcommands.
Caution The debug commands are primarily intended for use in controlled test and troubleshooting situations
with a limited volume of traffic.
Examples The following example shows how to enable debugging for the internal configuration file editor:
Router# debug cable config-file
CMTS config file debugging is on
Router# show debug
CMTS:
CMTS config file debugging is on
Router#
When debugging is turned on, the Cisco CMTS displays the following message when it generates a
DOCSIS configuration file for transmission to a CM:
4-11