Cisco Broadband Cable Command Reference Guide

Command Reference
Command Reference
3-4
Cisco Broadband Cable Command Reference Guide
Chapter 3 Commands for the Cisco uBR10012 Router
This section describes the following commands that are specific to the Cisco uBR10012 universal
broadband router:
associate, page 3-5
auto-sync, page 3-7
clear facility-alarm, page 3-9
clear pxf, page 3-11
facility-alarm, page 3-13
hw-module reset, page 3-16
hw-module shutdown, page 3-18
hw-module slot pos, page 3-20
hw-module slot srp, page 3-22
main-cpu, page 3-24
microcode, page 3-26
microcode reload, page 3-28
redundancy, page 3-30
redundancy force-failover main-cpu, page 3-32
secondary aux, page 3-34
show facility-alarm status, page 3-35
show hardware pxf cable, page 3-36
show hardware pxf cable interface, page 3-41
show hardware pxf cpu, page 3-44
show hardware pxf dma, page 3-60
show hardware pxf microcode, page 3-67
show hardware pxf xcm, page 3-70
show redundancy, page 3-73
switchover timeout, page 3-77
Note For information on the cable-specific commands for the Cisco uBR10012 router, see Chapter 2,
“Cisco Cable Modem Termination System Commands.” For information about debugging commands for
the Cisco uBR10012 router and other Cisco CMTS routers, see Chapter 4, “Cisco Cable Modem
Termination System Debugging Commands.”
OL-1581-05