Cisco Broadband Cable Command Reference Guide

show interface cable intercept
show interface cable intercept
Syntax Description
Command Modes Privileged EXEC
Command History
2-434
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To display the CMs for which traffic is currently being intercepted and forwarded to a data collector, use
the show interface cable intercept command in privileged EXEC mode.
show interface cable {slot/port | slot/subslot/port} intercept
slot/port Identifies the cable interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is 1/0. On the
Cisco uBR7200 series router, slot can range from 3 to 6, and port can be 0
or 1, depending on the cable interface.
slot/subslot/port Identifies the cable interface on the Cisco uBR10012 router. The following
are the valid values:
Examples The following shows a display after a CM has been added to the intercept list:
router# configure terminal
router#(config) interface c6/0
router(config-if)# cable intercept 0080.fcaa.aabb 10.12.13.8 512
router(config-if)# exit
router(config)# exit
router# show interface c6/0 intercept
Destination Destination
MAC Address IP Address UDP Port
0080.fcaa.aabb 3.12.13.8 512
router#
The following shows a display when no CMs have been added to the intercept list:
router# show interface c6/0 intercept
No interception active
router#
slot = 5 to 8
subslot = 0 or 1
port = 0 to 4 (depending on the cable interface)
Release Modification
12.0(5)T1 This command was introduced.
12.0(6)SC This command was introduced on the 12.0 SC train.
12.1(2)EC This command was introduced on 12.1 EC train.
12.2(4)BC1 This command was introduced on the 12.2 BC train.
OL-1581-05