Cisco Broadband Cable Command Reference Guide

show controllers cable-modem lookup-table
5-92
Cisco Broadband Cable Command Reference Guide
Chapter 5 Cable CPE Commands
Tip In Cisco IOS Release 12.2(8)T and later releases, you can add a timestamp to show commands using the
exec prompt timestamp command in line configuration mode.
Related Commands Command Description
show controllers cable-modem Displays high-level controller information about the cable interface.
show controllers cable-modem Displays information about the baseline privacy key management
bpkm
exchange between the the cable interface and the CMTS.
show controllers cable-modem Displays information about the Data Encryption Standard (DES)
des
engine registers.
show controllers cable-modem .Displays the registers in the MAC hardware that are used for
filters
filtering received frames.
show controllers cable-modem
mac
Displays detailed MAC-layer information for the cable interface.
show controllers cable-modem Displays the contents of the registers used in the downstream
phy
physical hardware of the cable interface.
show controllers cable-modem Displays the settings for the upstream and downstream tuners used
tuner
by the cable interface.
OL-1581-05