Cisco Broadband Cable Command Reference Guide

Chapter 4 Cisco Cable Modem Termination System Debugging Commands
debug cable startalloc
OL-1581-05
Cisco Broadband Cable Command Reference Guide
debug cable startalloc
To debug channel allocations on the HFC network, use the debug cable startalloc command in
privileged EXEC mode. To disable debugging output, use the no form of this command.
debug cable startalloc
no debug cable startalloc
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Release Modification
11.3NA This command was introduced.
Usage Guidelines This command activates debugging of the channel allocations on the HFC network. When this command
is activated, any messages generated when channels are allocated to CMs on the HFC network are
displayed on the Cisco CMTS console.
Caution This command should be used for development testing only, not in production setting.
Examples The following shows sample output from the debug cable startalloc command:
Router# debug cable startalloc
Router#
00:53:27: Cable3/U0 MAP startalloc adjusted by 1 mslots
00:53:27: Cable4/U0 MAP startalloc adjusted by 3 mslots
00:53:27: Cable3/U0 MAP startalloc adjusted by 5 mslots
00:53:27: Cable4/U0 MAP startalloc adjusted by 4 mslots
00:53:28: Cable3/U0 MAP startalloc adjusted by 4 mslots
00:53:28: Cable4/U0 MAP startalloc adjusted by 5 mslots
4-59