Cisco Broadband Cable Command Reference Guide

cable flap-list size
cable flap-list size
Syntax Description
Defaults 100
2-72
Cisco Broadband Cable Command Reference Guide
Chapter 2 Cisco Cable Modem Termination System Commands
To specify the maximum number of CMs that can be listed in the flap-list table, use the cable flap-list
size command in global configuration mode. To specify the default flap-list table size, use the no form
of this command.
cable flap-list size number
no cable flap-list size
Command Modes Global configuration
Command History
Examples The following example shows how to limit the flap-list table size to contain a maximum of 200 CMs:
Related Commands
number Specifies the maximum number of CMs that will report flap
performance to the flap-list table. Valid values are from 1 to 8191, with
a default of 100 CMs.
Release Modification
12.1 T This command was introduced.
router(config)# cable flap-list size 200
Command Description
cable flap-list aging Specifies the number of days to keep a CM in the flap-list table before aging
it out of the table.
cable flap-list
insertion-time
cable flap-list
miss-threshold
cable flap-list
power-adjust
threshold
Sets the insertion time interval that determines whether a CM is placed in the
flap list.
Specifies miss threshold for recording a flap-list event.
Specifies the power-adjust threshold for recording a CM flap-list event.
clear cable flap-list Clears all the entries in the flap-list table.
debug cable flap Displays information about the operation of the CM flap list that is
maintained for the cable interfaces.
ping docsis Sends a DOCSIS ping to a CM and increments the flap-list counters as
appropriate.
show cable flap-list Displays the current contents of the flap list.
OL-1581-05