Cisco Broadband Cable Command Reference Guide

Chapter 5 Cable CPE Commands
ip http cable-monitor
Syntax Description
OL-1581-05
Cisco Broadband Cable Command Reference Guide
ip http cable-monitor
To enable the cable access router’s onboard Cable Monitor web server, use the ip http cable-monitor
command in global configuration mode. To disable the Cable Monitor and turn off all access to the
onboard Cisco web server, use the no form of this command.
Cisco uBR905, uBR924, uBR925 cable access routers, Cisco CVA122 Cable Voice Adapter
ip http cable-monitor {basic | advance} [url-ip-address url-mask]
no ip http cable-monitor
Defaults For url-ip-address, 192.168.100.1
For url-mask, 255.255.255.0
Command Modes Global configuration
Command History
basic Displays only the basic status and performance pages.
advance Displays all status and diagnostic pages.
Note The Cable Monitor should not be used in advanced mode without
first implementing a secure password strategy on the cable access
router. Enabling the Cable Monitor in advanced mode without
setting an encrypted enabled password could provide information
that would allow remote users to change the router’s configuration.
url-ip-address (Optional) Specifies the IP address for the Cable Monitor. This argument,
along with the url-mask argument, also defines the network that provides
the IP address pool used by the temporary DHCP server when the cable
interface goes down.
url-mask (Optional) Specifies the subnet mask for the Cable Monitor. This argument,
along with the url-ip-address argument, also defines the network that
provides the IP address pool used by the temporary DHCP server when the
cable interface goes down.
Release Modification
12.1(1)T This command is introduced for the Cisco uBR924 cable access router.
12.1(3)XL Support was added for the Cisco uBR905 cable access router.
12.1(5)XU1 Support was added for the Cisco CVA122 Cable Voice Adapter.
12.2(2)XA Support was added for the Cisco uBR925 cable access router.
Usage Guidelines This command enables the Cable Monitor, an onboard web server that displays current status,
troubleshooting, and performance information. The Cable Monitor can be accessed in two ways:
5-57