Cisco Broadband Cable Command Reference Guide

Chapter 2 Cisco Cable Modem Termination System Commands
show cable burst-profile
OL-1581-05
show cable burst-profile
To display the upstream data burst profiles used to configure the upstream PHY, use the show cable
burst-profile command in privileged EXEC mode.
show cable burst-profile
Note This command has been deprecated and removed in the current versions of the Cisco IOS software for
all Cisco CMTS routers.
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Release Modification
11.3 NA This command was introduced.
11.3(5)NA, 12.0(5)T1, This command was removed and replaced with the show cable
12.0(6)SC, 12.1(2)EC1 modulation-profile command.
Usage Guidelines This command displayed configuration of the cable burst profiles, which were what DOCSIS initially
used to control the data, ranging, and station maintenance bursts. The Cisco CMTS routers now support
a more comprehensive set of modulation profiles, which are displayed by the show cable
modulation-profile command.
Note The show cable burst-profile command displayed fields and values that were supported only in the
initial versions of the DOCSIS specification. The current DOCSIS 1.0 and 1.1 specifications use
different parameters and values, as shown by the show cable modulation-profile command.
Examples The following example shows typical output from the show cable burst-profile command:
Router# show cable burst-profile
Burst Type Preamb Diff FEC err FEC Scrambl Max Guard Last Scrambl profile
number length size size shortened
1 1 48 no 0x0 0x6 0x152 1 16 1 yes
2 1 48 no 0x0 0x6 0x152 1 12 1 no
3 1 48 no 0x5 0x2C 0x152 0 48 1 yes
4 1 48 no 0x5 0x2C 0x152 0 48 1 yes
5 1 48 no 0x5 0x32 0x152 0 20 1 yes
6 1 48 no 0x0 0x32 0x152 0 20 1 no
Router#
Cisco Broadband Cable Command Reference Guide
2-345