Cisco Broadband Cable Command Reference Guide

Chapter 4 Cisco Cable Modem Termination System Debugging Commands
debug hccp events
OL-1581-05
Cisco Broadband Cable Command Reference Guide
debug hccp events
To display debug messages for all HCCP group interaction, use the debug hccp events command in
privileged EXEC mode. To disable HCCP group debug message output, use the no form of this
command.
debug hccp events
no debug hccp events
Syntax Description This command has no arguments or keywords.
Command History
Usage Guidelines You must use the debug hccp events command to activate HCCP debugging before the other debug
hccp commands will display debugging output.
Examples The following example shows HCCP group interaction debug message output produced when the debug
hccp events command has been activated:
Related Commands
Release Modification
12.1(3a)EC This command was introduced.
12.2(4)XF1,
12.2(4)BC1
Support was added for the N+1 RF Switch with the Cisco uBR10012 router.
12.2(11)BC1 Support was added for the N+1 RF Switch with the Cisco uBR7246VXR
router.
Router# debug hccp events
Sep 7 09:51:50.151:HCCP 1 0->1:HELLO Learn tran 31708
Command Description
debug hccp
authentication
Displays authentication debug messages for HCCP groups.
debug hccp
Displays debug messages related to an RF or channel switch that is being
channel-switch used for HCCP N+1 redundancy.
debug hccp inter-db Displays debug messages for the inter-database events during HCCP
operations.
debug hccp plane Displays debug messages for HCCP-related messages sent between the
router’s control plane and data backplane.
debug hccp sync Displays debug messages for HCCP synchronization messages.
debug hccp timing Displays debug messages for the timing of HCCP events.
4-85