OPERATION MANUAL CompoBus/S

C200HW-SRM21-V1 Master Unit for CS-series, C200HX/C200HG/C200HE-(Z)E, and C200HS PLCsSection 4-1
When an even node number has been set:
Bits 0 to 3 are used and bits 4 to 7 are not used.
Example: When a Slave with 4 outputs and 4 inputs is set to node number 2,
the rightmost 4 bits (bits 0 to 3) of the area for node number 2 for both output
and input are used.
First word + 5
(IN0 to IN7 and OUT0 to OUT7)
First word + 9
(IN0 to IN15 and OUT0 to OUT15)
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
First word + 1
Output Slave 3
Output Slave 2
Bit 7
0 Reserved Bit 3 0
Bit 7
8-point I/O Slave
4 outputs
4 inputs
Input Slave 3
Slave with 32 Outputs or 32 Inputs
The Slave is treated as four node numbers for output or input and is allocated
2 consecutive words, as follows:
When an odd node number has been set:
Uses (node number setting – 1) to (node number setting + 2)
When an even node number has been set:
Uses (node number setting) to (node number setting + 3).
Example: When a Slave with 32 outputs is set to node number 1, it uses the
area assigned for Output Slave 0 to Output Slave 3. The area for Output Slave
0, 2, and 3 cannot be used for another Output Slave.
Slave with Mixed I/O (16 Outputs and 16 Inputs)
Slaves that have both outputs and inputs are also assigned a single node
number, so the same node number is used for both outputs and inputs, and
each is regarded as two node numbers. Outputs and inputs are allocated to
the same words, as follows:
When an odd node number has been set:
Uses (node number setting – 1) and (node number setting)
When an even node number has been set:
Uses (node number setting) and (node number setting + 1).
0
Reserved
Set to node number 2.
Input Slave 2
Bit 3
Bits
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
First word + 0
Output Slave 1
Output Slave 0
Bit 7
0 Bit 7
0
First word + 1
Output Slave 3
Output Slave 2
Bit 7
0 Bit 7
0
Set to node number 1
32-output Slave
32 outputs
Bits
0
83