OPERATION MANUAL CompoBus/S

Master/Slave Connecting Cables Section 3-4
Sensor terminal Sensor type Terminal number
1 2 3 4
SRT2-VID08S-1 3-wire sensor
(without self-diagnostic output
function)
2-wire sensor
(without self-diagnostic output
function)
Black (white)
(Connect to 1 or
2)
Blue (black)
(Connect to 1 or
2)
Note In accordance with the changes in the standards for photoelectric sensors
and proximity sensors, wire colors have been changed. Colors in parentheses
are the old wire colors.
When connecting an output device, match the terminal numbers marked on
the connector cover with the signal wires of the output device as shown in the
following table.
Sensor terminal Terminal number
1 2 3 4
SRT2-VOD08S Yes (Connect to 1 or 2) Yes ---
SRT2-VOID08S-1 Yes (Connect to 1 or 2) --- Yes
SRT@-OD08S Yes --- Yes (Connect to 3 or 4)
Insert the wire all the way into the cover’s hole until it touches.
Connector Assembly
Use the following procedure to assemble the cable connector.
Brown
(red)
Brown
(white)
Blue
(black)
Sensor terminal Sensor type Terminal number
1 2 3 4
SRT@-ID08S 3-wire sensor
Black --- Brown Blue
(without self-diagnostic output
function)
(white) (red) (black)
2-wire sensor
Brown --- --- Blue
(without self-diagnostic output
function)
(white)
(black)
SRT@-ND08S Sensor with teaching func- Black Pink Brown Blue
tion or external diagnostic
function
(white) (gray) (red) (black)
Sensor with bank switching
function
Black Purple Brown Blue
1,2,3... 1. Check the wire colors and make sure that the sensor’s wires are aligned
with the correct terminal numbers. (The cover is semi-transparent, so the
wire colors will be visible through the cover.)
2. Fit the cover (with wires inserted) into the connector plug, as shown in the
following diagram.
3. Use a tool such as pliers to press the cover all the way into the connector
plug. Always align the tool with the center of the cover so it does not tilt,
---
69