OPERATION MANUAL CompoBus/S

Sensor Amplifier Terminals Section 5-11
2. When Section D releases from the lock, the Connector Unit can be removed.
Expanding Sensor Amplifier Terminals
1,2,3... 1. Remove the cover from the side of the SRT@-T@D04S. When the cover is
removed, the expansion connector can be seen inside.
Removing Contact
Connector Cover
Section D
Push here
2. Connect this expansion connector to the connector located on the side of
the SRT@-X@D04S.
SRT-TD04S
Connector
Cover
Contacts 1 through 3 of the SRT@-TID04S are covered with a contact connector
cover. When using these contacts, refer to the following figure and pull
out and remove Section A of the contact connector cover in the direction of its
end.
Contact connector cover
E
SRT-XD04S
Side view
Section A
345