OPERATION MANUAL CompoBus/S

Operations Checklist Section 3-5
CS-series Master
Units
CJ-series Master
Units
CQM1 Master
Units
Item Check Answer
Switch settings Has the Master’s Special I/O Unit number been set?
(Refer to 4-2-2 Switch Settings for details.)
Has the node number been set with pin 1 of the DIP switch?
(Refer to 4-2-2 Switch Settings for details.)
Has the communications mode been set with pin 2 of the DIP switch?
(Refer to 4-2-2 Switch Settings for details.)
Has the communications stop mode been set with pin 3 of the DIP
switch?
(Refer to 4-2-2 Switch Settings for details.)
Has the Slave registration function been set with pin 4 of the DIP
switch? (If the Slave registration function is used, the CPU Unit’s DM
Area must also be set.)
(Refer to 4-2-2 Switch Settings for details.)
Switch settings Has the Master’s Special I/O Unit number been set?
(Refer to 4-3-2 Switch Settings for details.)
Has the node number been set with pin 1 of the DIP switch?
(Refer to 4-3-2 Switch Settings for details.)
Has the communications mode been set with pin 2 of the DIP switch?
(Refer to 4-3-2 Switch Settings for details.)
Has the communications stop mode been set with pin 3 of the DIP
switch?
(Refer to 4-3-2 Switch Settings for details.)
Has the Slave registration function been set with pin 4 of the DIP
switch? (If the Slave registration function is used, the CPU Unit’s DM
Area must also be set.)
(Refer to 4-3-2 Switch Settings for details.)
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Switch settings Has the PLC word allocation (DIP switch pins 1 and 2) been set?
(Refer to 4-4-2 Switch Settings for details.)
Yes No
Has the number of points/node number setting (DIP switch pin 3)
been set? (Refer to 4-4-2 Switch Settings for details.)
Yes No
Has the communications mode been set with pin 4 of the DIP switch?
(Refer to 4-4-2 Switch Settings for details.)
Yes No
Are pins 5 and 6 of the DIP switch all set to OFF? Yes No
Slaves Switch settings Has the node number been set?
(Refer to SECTION 5 Slave Specifications and Operations for
details.)
Has the communications mode been set?
(Refer to SECTION 5 Slave Specifications and Operations for
details.)
Yes No
Yes No
Is the Slave’s node number unique (not allocated to another Slave)? Yes No
Have other settings besides the CompoBus/S settings, such as the
“hold/clear outputs for communications error” setting, been set?
(Refer to SECTION 5 Slave Specifications and Operations for
details.)
Yes No
71