OPERATION MANUAL CompoBus/S

Connector Terminals Section 5-2
214
Item Specification
Terminal strength Pulling: As stated below
Communications connector: 100 N
Cable connector: 40 N
MIL Connector: 100 N
Tightening: 0.25 N m (for communications connector)
Node number settings The node number is set on a DIP switch. (Set the node
number before turning ON the Slave.)
Weight Approx. 75 g
Note This is the current consumption when all the maximum simultaneous output
points are ON, excluding the current consumption of external sensors.
Output Specifications
Item VOD08S/VOD08S-1 VOD16ML/VOD16ML-1
Output current 0.3 A max./point 0.3 A max./point (2 A common)
(See note.)
Residual voltage VOD08S/VOD16ML: 1.2 V DC max. (between each input
terminal and G)
VOD08S-1/VOD16ML-1: 1.2 V DC max. (between each input
terminal and V)
Leakage current VOD08S/VOD16ML: 0.1 mA max.
VOD08S-1/VOD16ML-1: 0.1 mA max.
ON delay time 0.5 ms max.
OFF delay time 1.5 ms max.
Insulation method Photocoupler
Number of circuits 8 points/single common circuit 16 points/single common circuit
Note When using the V and G terminals of the MIL connector, make sure that current
does not exceed 1 A at each terminal.