OPERATION MANUAL CompoBus/S

Water-resistant Terminals Section 5-4
Connectors for External Power Supply
Connector type Model
Round Water-resistant Connectors with XS2W-D42@-@81-@
Cable (socket and plug)
Round Water-resistant Connector with XS2F-D42@-@80-@
Cable (socket on one end)
Connector Socket Assembly (female) XS2C-D4@@
(Crimp terminals/Solder terminals)
I/O power supply
XS2F-D42-80- Round
Water-resistant Connector
with Cable (socket on one
end)
I/O Connectors
SRT2-ID04CL
XS2R-D427-5 T-joint
Connector type Model
Connector with cable (male plug on one end) XS2H-D421-@80-A
Round Water-resistant Connectors with Cable (socket and
plug)
XS2W-D42@-@81-A
Connector Socket Assembly (female) (Crimp terminals/Solder
terminals)
XS2G-D4@
The sensor with a relay connector can directly connect to the Unit.
When connecting a device, check the pin arrangement of the device with the
datasheet.
XS2W-D42-81-A
Round Water-resistant
Connectors with Cable
(socket and plug)
Sensor with built-in connector
Sensor with relay connector
SRT2-ID08CL
I/O power supply
XS2W-D42-81- Round
Water-resistant Connectors
with Cable (socket and plug)
XS2F-D42-81- Round
Water-resistant Connector
with Cable (socket on one
end)
I/O power supply
XS2R-D427-5 T-joint
Press the cable connector to the terminal connector until the cable connector
comes in contact with the bottom end of the cable connector. Tighten the connector
screws to the specified tightening torque (0.39 to 0.49 N⋅m).
!Caution Tighten the connector securely by hand to a torque of 0.39 to 0.49 N⋅m. If the
connector is not tightened securely, the connector will be loosened or cannot
keep the enclosure rating. Do not tighten the connector with tools such as pliers,
or otherwise the connector may be broken.
!Caution Connectors vary in direction. Check the direction before inserting the connector.
!Caution Do not pull or bend the cable. Provide some margin when laying the cable.
Check that the cable is free of heavy objects, or otherwise the cable may be
broken.
XS2G
XS2H-D421-80-A
Connector with cable
(male plug on one
end)
Sensor with cord
285