OPERATION MANUAL CompoBus/S

Checking Operations of CS-series and CJ-series Master Units Section 6-3
Word Bit Name Function
+6 00 Output Slave Verification OUT0 When the Slave registration
01
02
Error: Slave Missing
OUT1
OUT2
function is enabled, the bit
corresponding to the node
number of the Output Slave
to to that caused the verification
13
14
15
OUT13
OUT14
OUT15
error (Slave missing) will be
turned ON.
Bits 00 to 15 correspond to
Output Slave node numbers 1
to 15. When the Slave that
caused the verification error
joins the network, the bit will
automatically turned OFF.
+7 00 Input Slave Verification IN0 When the Slave registration
01
02
Error: Slave Missing IN1
IN2
function is enabled, the bit
corresponding to the node
number of the Input Slave that
to to caused the verification error
13
14
15
IN13
IN14
IN15
(Slave missing) will be turned
ON.
Bits 00 to 15 correspond to
Input Slave node numbers 1
to 15. When the Slave that
caused the verification error
joins the network, the bit will
automatically turned OFF.
+8 00 Output Slave Verification OUT0 When the Slave registration
01
02
Error: Unregistered Slave
in Network
OUT1
OUT2
function is enabled, the bit
corresponding to the node
number of the Output Slave
to to where a verification error
13
14
15
OUT13
OUT14
OUT15
(unregistered Slave in network)
will be turned ON.
Bits 00 to 15 correspond to
Output Slave node numbers 1
to 15.
Once a bit has been turned
ON the status will be held until
the power is turned OFF and
ON again or the Unit is
restarted.
+9 00 Input Slave Verification IN0 When the Slave registration
01
02
Error: Unregistered Slave
in Network
IN1
IN2
function is enabled, the bit
corresponding to the node
number of the Input Slave
to to where a verification error
13
14
15
IN13
IN14
IN15
(unregistered Slave in network)
will be turned ON.
Bits 00 to 15 correspond to
Input Slave node numbers 1
to 15.
Once a bit has been turned
ON the status will be held until
the power is turned OFF and
ON again or the Unit is
restarted.
370
The bits in the Special I/O
Unit Area correspond to the
node numbers actually used
by the Slaves. Therefore, for
Slaves with 16 points or
higher, the bits other than
those set for the node number
may also be turned ON. For
example, the two consecutive
bits used by a 16-point Slave
or the four consecutive bits
used by a 32-point Slave may
be turned ON at the same
time.