OPERATION MANUAL CompoBus/S

Connector Terminals Section 5-2
c. Secure Mounting Bracket A
on DIN Track with two
Phillips screws. These
screws are provided with
Mounting Bracket A.
b) Secure both sides of the Connector Terminal with two end plates.
End Plates
2. Mounting on DIN Track with Connector Side Facing Upward (Mounting
Brackets A and B Required)
Connector
side up
Hook the bottom, then the top of
the end plate over the track, and
fasten with a screw.
a) Secure Mounting Bracket A on the DIN Track with two Phillips screws.
b. Hitch top hooks
onto DIN Track.
Mounting Bracket A
DIN Track
a. Hitch bottom hooks
onto DIN Track.
b) Press the Connector Terminal down into Mounting Bracket A.
b. Pressing the Connector
Terminal downward will
cause the DIN Track
mounting hooks to engage
automatically.
DIN Track
a. Hook the Connector
Terminal onto the inner
ridge.
Mounting Bracket A
209