OPERATION MANUAL CompoBus/S

Connector Terminals Section 5-2
Compatible External Input
Devices and Cables
Connector Terminals with 32 inputs connect to external devices over one of
the following method.
1,2,3... 1. Using an XG4A-4030-T MIL Connector (sold separately) to Assemble Your
Own Cable
For details, refer to MIL Connector Wiring and Assembly on page 258.
Insert with protrusion
facing right.
2. Connecting with OMRON Products Using MIL-compatible Cables Manufactured
by OMRON
Select the MIL-compatible Cable from the following table according to the
Connector Terminal and I/O Block to be connected.
Slave model MIL-compatible Cable Connecting I/O block
SRT2-ID32ML G79-I50-25-D1 (50 cm)
G79-I75-50-D1 (75 cm)
SRT2-ID32ML-1 G79-I50-25-D2 (50 cm)
G79-I75-50-D2 (75 cm)
G7TC-ID16
G7TC-IA16
G70A-ZIM16-5
Note MIL-compatible cables are not provided as standard and must be ordered
separately.
The following cables are available, each of which is provided with a single MIL
connector for the Connector Terminal end.
MIL-compatible cable Remarks
G79-A200C-D1 (2 m)
G79-A500C-D1 (5 m)
G79-Y100C-D1 (1 m)
G79-Y200-D1 (2 m)
G79-Y500C-D1 (5 m)
Wire dia.: AWG28 (other end)
All wires are precut.
Fork terminals provided to other end.
Fork terminal: Nippon Tanshi’s 161071-
M2
233