OPERATION MANUAL CompoBus/S

Connector Terminals Section 5-2
254
1,2,3... 1. Using an XG4A-4030-T MIL Connector (sold separately) to Assemble Your
Own Cable
For details, refer to MIL Connector Wiring and Assembly on page 258.
Insert with protrusion facing right.
2. Connecting with OMRON Products Using an MIL-compatible Cables Manufactured
by OMRON
Select the MIL-compatible Cable from the following table according to the
Connector Terminals and I/O Block to be connected.
Slave model MIL-compatible Cable Connecting I/O block Remarks
SRT2-MD32ML G79-M50-25-D1 (50 cm)
G79-M75-50-D1 (75 cm)
SRT2-MD32ML-1 G79-M50-25-D2 (50 cm)
G79-M75-50-D2 (75 cm)
Inputs:G7TC-ID16/IA16
Outputs:G7TC-OC08/OC16
G7OD-SOC16/VSOC16
G70A-ZOC16-3
Inputs:G70A-ZIM16-5
Outputs:G70A-ZOC16-4
G70D-SOC16-1
Input and output wires can
be distinguished with the
following colors.
Inputs: Red
Outputs: Yellow
Note MIL-compatible cables are not provided as standard and must be ordered
separately.
The following cables are available, each of which is provided with a single MIL
connector for the Connector Terminal end.
MIL-compatible cable Remarks
G79-A200C-D1 (2 m)
G79-A500C-D1 (5 m)
G79-Y100C-D1 (1 m)
G79-Y200C-D1 (2 m)
G79-Y500C-D1 (5 m)
Wire dia.: AWG28 (other end)
All wires are precut.
Fork terminals provided to other end.
Fork terminal: Nippon Tanshi’s 161071-M2