OPERATION MANUAL CompoBus/S

Connector Installation (Special Flat Cable Only) Section 3-2
1,2,3... 1. Make a perpendicular cut in the cable being used as the main line (the
main cable). The cable will not fit in the connector properly if the cut is not
straight and perpendicular.
Correct Incorrect
2. Snap Cover 1 onto the main cable. Make sure that the hook locks into
place.
Hook
3. Line up the end of Cover 1 with the end of the main cable.
0.5 mm max.
4. Position Cover 1 onto Surface 1 of the contact block (the side with the cable
stop).
Cover 1
Contact block
Main cable
Cable
Cover number
5. Make sure that the cable has been inserted all the way to the contact
block’s cable stop.
6. Use a tool such as pliers to compress Cover 1 and the contact block together.
63