OPERATION MANUAL CompoBus/S

Connector Terminals Section 5-2
Item Specification
Connection Input SRT2-VID08S (-1):
By XS8A-0441 Connector or XS8A-0442 Connector
(both sold separately)
SRT2-VID16ML (-1):
By XG4M-2030-T MIL Connector (sold separately),
or G79-050C, G79-025C, G79-150C and
G79-125C MIL-compatible Cables (all sold separately)
Communications
power
I/O power
Power supply type Multiple power supplies
Communications power supply
voltage
By communications connector (included as standard)
14 to 26.4 V DC
(Power can be supplied from the communications
cable)
I/O power supply voltage 20.4 to 26.4 V DC (24 V DC +10% / –15% )
I/O power supply current Cable connector: 2.4 A max.
MIL connector: 2.0 A max.
Current consumption
Communications power: 50 mA max. at 24 V DC
(See note.)
Noise immunity ±1.5 kVp-p with a pulse width of 0.1 to 1 µs and a
rise time of 1 ns (tested with impulse noise simulator)
Vibration resistance 10 to 150 Hz, 1.0-mm double amplitude or 70 m/s2 Shock resistance 200 m/s 2
Dielectric strength 500 V AC (between insulated circuits)
Ambient temperature Operating: –10 to 55°C
(with no icing or condensation)
Storage: –25 to 65°C
(with no icing or condensation)
Ambient humidity Operating: 25% to 85% (with no condensation)
Storage: 25% to 85% (with no condensation)
Operating environment No corrosive gases
Standard accessory 1 communications connector
Note: Mounting Brackets A (SRT2-ATT01) and B
(SRT2-ATT02) are sold separately.
Mounting strength Pulling: 100 N in each direction.
(When mounted with Mounting Bracket B: 40 N)
Terminal strength Pulling: As stated below.
Communications connector: 100 N
Cable connector: 40 N
MIL connector: 100 N
Tightening: 0.25 N m (for communications connector)
Node number settings The node number is set on a DIP switch. (Set the
node number before turning ON the Slave.)
Weight Approx. 75 g
Note This is the current consumption when all the maximum simultaneous input
points are ON, excluding the current consumption of external sensors.
195