OPERATION MANUAL CompoBus/S

Connector Terminals Section 5-2
Slave Components The following diagram shows the main components of the SRT2-VOD@@@@
(-@) Connector Terminals with Transistor Outputs. The functions of these
components are described below.
Models with Sensor Connectors
SRT2-VOD08S/VOD08S-1
Communications connector
Used to connect CompoBus/S communications data (BD H, BD L), communications
power supply, and I/O power supply (see page 256).
One compatible connector is provided as standard.
Indicators
Indicate the status of the Slave and communications, and
output status of each contact. (Lit when the output is ON.)
View from (A) (base)
DIN Track Mounting Hook
DIP Switch
The DIP switch's pins have the following functions:
Pins 1 to 4: Node number setting
Pins 5 and 6: Reserved (Always OFF.)
Pin 7: Communications mode setting
Pin 8: Hold/Clear outputs for communications error
Output connector (cable connector)
Connect 8 outputs with cable connector
The XS8A-0441 Cable Connector (compatible conductor size: 0.3 to 0.5 mm2 ) and XS8A-0442 Cable
Connector (compatible conductor size: 0.14 to 0.2 mm2 (see page 67).
The XS8A-0441 Cable Connector (compatible conductor size: 0.3 to 0.5 mm
) are sold separately.
2 ) and XS8A-0442 Cable
Connector (compatible conductor size: 0.14 to 0.2 mm 2 ) are sold separately.
215