OPERATION MANUAL CompoBus/S

I/O Link Units for CPM1A and CPM2A Section 5-9
5-9 I/O Link Units for CPM1A and CPM2A
5-9-1 CPM1A-SRT21 I/O Link Unit for CPM1A and CPM2A
Specifications The following table shows the ratings and I/O specifications for the CPM1A-
SRT21.
Ratings
Item Specification
Model CPM1A-SRT21
I/O points 8 input points, 8 output points
(All the I/O points use the same node number. I/O is performed
only with I/O memory of CPM1A/CPM2A, not with
external devices.)
Connection to CPM1A/ Connect expansion I/O connecting cable to the expansion
CPM2A
connector of the CPU Unit or the Expansion Unit.
Power supply type ---
Communications power Supplied from CPM1A or CPM2A CPU Unit. (See note.)
supply and internal circuits
power supply
Vibration resistance Conforming to JIS C0911
10 to 57 Hz with single-amplitude of 0.075 mm
57 to 150 Hz with fixed acceleration of 9.8 m/s 2
80 minutes each in X, Y, and Z directions (8 minutes per
sweep × 10 sweeps = 80 minutes)
Shock resistance Conforming to JIS C0912
Peak acceleration of 147 m/s 2 3 times each in X, Y, and Z
directions
Ambient temperature Operating: 0 to 55°C (with no icing or condensation)
Storage: –20 to 75°C (with no icing or condensation)
Ambient humidity Operating: 10% to 90% (with no condensation)
Storage: 10% to 90% (with no condensation)
Operating environment No corrosive gases
Node number settings The node number is set on a DIP switch. (Set the node
number before turning ON the CPM1A or CPM2A CPU
Unit.)
Weight Approx. 200 g
Note CompoBus/S communications and common I/O terminals are not used.
327