OPERATION MANUAL CompoBus/S

Connector Terminals Section 5-2
Dimensions
The pin numbers of the MIL connector corresponds to the following color
wires marked with color dots.
Pin Wire
color
1 Light
brown
Dots Dot
color
Pin Wire
color
Dots Dot
color
■ Black 21 Light ■■■ Black
2 Red 22 brown
Red
3 Yellow Black 23 Yellow Black
4 Red 24 Red
5 Light
Black 25 Light
Black
6 green
Red 26 green
Red
7 Gray Black 27 Gray Black
8 Red 28 Red
9 White Black 29 White Black
10 Red 30 Red
11 Light ■■ Black 31 Light ■■■■ Black
12 brown
Red 32 brown
Red
13 Yellow Black 33 Yellow Black
14 Red 34 Red
15 Light
Black 35 Light
Black
16 green
Red 36 green
Red
17 Gray Black 37 Gray Black
18 Red 38 Red
19 White Black 39 White Black
20 Red 40 Red
(Unit: mm)
Note For details on wiring dimensions, refer to 5-2-3 SRT2-ID32ML (-1) Connector
Terminals with 32 Transistor Inputs.
Mounting Methods The following mounting methods are available. These methods are the same
as those used for mounting Connector Terminals with 8 or 16 inputs.
DIN track mounting (with no mounting brackets): Refer to page 208.
Vertical panel mounting (with Mounting Bracket B only): Refer to
page 210.
Horizontal panel mounting (with Mounting Bracket B only): Refer to
page 210.
Note 1. The 32-point Connector Terminal cannot be directly panel-mounted with
screws. Use the SRT2-ATT02 Mounting Bracket B.
255