OPERATION MANUAL CompoBus/S

Connector Terminals Section 5-2
Mounting Methods The following mounting methods can be used. These methods are the same
as those used for mounting Connector Terminals with 8 or 16 inputs.
DIN track mounting (with no mounting brackets): Refer to page 208.
Vertical panel mounting (with Mounting Bracket B only): Refer to
page 210.
Horizontal panel mounting (with Mounting Bracket B only): Refer to
page 210.
Note The 32-point Connector Terminals cannot be directly panel-mounted with
screws. Use the SRT2-ATT02 Mounting Bracket B.
Mounting Bracket
SRT2-ATT02 Mounting Bracket B
Dimensions
Mounting dimensions
Mounting Dimensions
Direct DIN Track Mounting Vertical Panel Mounting
DIN track
Mounting
bracket B
Mounting
bracket B
Two, 3.2 dia. or M3 holes.
(Unit: mm)
Distance from Duct
Keep the Unit at least 20 mm away from the upper and lower ducts.
Duct
Duct
0.1
Horizontal Panel
Mounting
SRT2
PWR
COMM1 COMM2
ERR1 ERR2
I
0 8 0 8
1 9 1 9
2 10 2 10
3 11 3 11
4 12 4 12
5 13 5 13
6 14 6 14
7 15 7 15
BS+
BSH
BSL
BS−
NC
NC
(Unit: mm)
IN
45 35
(Unit: mm)
235