OPERATION MANUAL CompoBus/S

Connector Installation (Special Flat Cable Only) Section 3-2
the track. Attach End Plates at the sides of the Slave to prevent it from sliding
on the track.
End Plate
!Caution Always secure the Slave on the DIN track by installing End Plates on each
side.
Mounting Direction
Any of the following six mounting directions can be used, unless specified in
the Slave’s operation manual.
PWR
SRT1-ID16
1 3 5 7 9 11 13 15
REMOTE TERMINAL
24VDC
COMM
0 2 4 6 8 10 12 14
ERR
No.
IN
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
3-2 Connector Installation (Special Flat Cable Only)
1 3 5 7 9 11 13 15
PWR
SRT1-ID16
REMOTE TERMINAL
24VDC
COMM
ERR
No.
0 2 4 6 8 10 12 14
IN
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Vertical
The cable connections can be made with simple connectors if Special Flat
Cable is used for the communications cable. There are three types of connectors:
the Branch Connector (refer to 3-2-1 Branch Connector), Extension Connector
(refer to 3-2-2 Extension Connector), and Connector Terminator (refer
to 3-2-3 Connector Terminator).
!Caution Connectors cannot be reused once they have been attached to a cable. Be
sure that the connectors are positioned correctly before attaching them.
!Caution Wire the communications cable separately from power lines and high-voltage
lines to prevent any noise.
!Caution If Special Flat Cables are used for multiple CompoBus/S Systems, install the
cables at least 5 mm apart from other Special Flat Cables to prevent unstable
operation due to mutual interference in the CompoBus/S Systems.
15
1 2 3 4 5 6 7 8 9 10 11 12 13 14
0
ERR
COMM
3 5 7 9 11 13 15
1
PWR
IN
No.
24VDC
TERMINAL
REMOTE
SRT1-ID16
0 2 4 6 8 10 12 14
IN
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
15
0 2 4 6 8 10 12 14
1 3 5 7 9 11 13 15
PWR
COMM
ERR
No.
SRT1-ID16
REMOTE TERMINAL
24VDC
55