cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 104/274
5.8 cifX Communication Interfaces PCI 104
5.8.1 Device Drawing CIFX 104C-RE
Note:
Device supports
Auto Crossover
Function
Note:
With loaded
EtherCAT
Master firmware
only RJ-45
channel 0 can
be used,
channel 1 is
deactivated.
For Open
Modbus/TCP
with V2.3.4.0
and higher both
channels can be
used.
Figure 21: Device Drawing CIFX 104C-RE
The meaning of the LEDs displayed in Figure 21 depends from the loaded
firmware. See chapter LED Descriptions beginning from page 200.
Further refer to Device Connections and Switches page 215:
For the SYNC pin assignment of the SYNC Connector displayed in Figure
21 refer to section Pin Assignment SYNC Connector, X51 on page 228.
Note: The Mini-B USB Connector displayed in Figure 21 can only be
used for future hardware revisions. For further information refer to section
Mini-B USB Connector (5 Pin) on page 221.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011