cifX Communication Interfaces Real-Time Ethernet - Hilscher

LED Descriptions 200/274
8 LED Descriptions
8.1 Overview
Note: The meaning of the communication status and the RJ45 LEDs at
the cifX Communication Interface is defined by the loaded cifX firmware of
the protocol.
LED Naming in
the Device
Drawing
EtherCAT-
Master
EtherCAT-
Slave
EtherNet/IP
LED Naming by Protocol
Open-
Modbus/TCP
Powerlink
PROFINET IO
SERCOS III-
Master
SERCOS III-
Slave
SYS (System
Status)
(yellow/green)
COM 0
(Communication
Status)
(red/green)
(orange
= red/green
simultaneously)
COM 1
(Communication
Status)
(red/green)
RJ45
Ch0 (green)
RJ45
Ch1
(yellow)
(green)
(yellow)
SYS SYS SYS SYS SYS SYS SYS SYS
RUN RUN MS RUN BS SF STA S3
(Run) (Run) (Module (Run) (Bus (System (Status) (Status/
Status)
Status) Failure)
Error)
ERR ERR NS ERR BE BF ERR -
(Error) (Error) (Network (Error) (Bus (Bus (Error)
Status)
Error) Failure)
LINK L/A IN LINK LINK L/A LINK L/A L/A
(Link)
(Link/
Activity
Input)
(Link) (Link) (Link/
Activity)
(Link)
(Link/
Activity)
(Link/
Activity)
ACT - ACT ACT - RX/TX - -
(Activity) (Activity) (Activity) (Receive/
Transmit)
- L/A OUT LINK LINK L/A LINK L/A L/A
(Link/
Activity
Output)
(Link) (Link) (Link/
Activity)
(Link)
(Link/
Activity)
(Link/
Activity)
- - ACT ACT - RX/TX - -
(Activity) (Activity) (Receive/
Transmit)
Table 48: Overview LEDs Real-Time Ethernet Systems
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011