cifX Communication Interfaces Real-Time Ethernet - Hilscher

LED Descriptions 209/274
LED State Definition for Powerlink Controlled Node/Slave for the
BS/BE LEDs
Indicator
state
On
Off
Blinking
Flickering
Single Flash
Double Flash
Triple Flash
Definition
The indicator is constantly on.
The indicator is constantly off.
The indicator turns on and off with a frequency of approximately
2,5 Hz: on for approximately 200 ms, followed by off for 200 ms. Red
and green LEDs shall be on alternately.
The indicator turns on and off with a frequency of approximately
10 Hz: on for approximately 50 ms, followed by off for 50 ms. Red
and green LEDs shall be on alternately.
The indicator shows one short flash (approximately 200 ms) followed
by a long off phase (approximately 1,000 ms).
The indicator shows a sequence of two short flashes (each
approximately 200 ms), separated by a short off phase
(approximately 200 ms). The sequence is finished by a long off
phase (approximately 1,000 ms).
The indicator shows a sequence of three short flashes (each
approximately 200 ms), separated by a short off phase
(approximately 200 ms). The sequence is finished by a long off
phase (approximately 1,000 ms).
Table 58: LED State Definition for Powerlink Controlled Node/Slave for the BS/BE LEDs
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011