cifX Communication Interfaces Real-Time Ethernet - Hilscher

Device Connections and Switches 228/274
9.9 SYNC Connector (Pin-Assignment, Hardware/Firmware)
9.9.1 Pin Assignment SYNC Connector, X51
Only for:
CIFX 50-RE (since hardware Rev. 3), CIFX 50E-RE,
CIFX 80-RE, CIFX 90-RE\F,
CIFX 104C-RE, CIFX 104C-RE-R, CIFX 104C-RE\F, CIFX 104C-RE-R\F,
CIFX 104-RE, CIFX 104-RE-R, CIFX 104-RE\F, CIFX 104-RE-R\F.
Pin
Signal
1 GND
2 IO_SYNC0
3 IO_SYNC1
Table 74: Pin Assignment for SYNC Connector, X51
CIFX 90E-RE\F: The SYNC pins are on the Mini PCI Express port (Pin 46,
44), refer to section Pin Assignment for Mini PCI Express Bus / SYNC
Connector (Bootstart), X1/X2, on page 233.
9.9.2 Pin Assignment SYNC Connector, J3
Only for: CIFX 100EH-RE\CUBE.
Pin Signal
1 IO_SYNC0
2 Jumper set: SYNC signal is transferred to the PCI-Express Bus Pin B24*
Jumper not set: static high 3,3 V (with pull-up)
3 IO_SYNC1
Table 75: Pin Assignment for SYNC Connector, J3
Note! *
• If the jumper is set on Pin1-Pin2, the IO_SYNC0 signal is transferred to
the PCI Express Bus X2 (pin B24).
Or
• If the jumper is set on Pin2-Pin3, the IO_SYNC1 signal is transferred to
the PCI Express Bus X2 (pin B24).
Or
• If the no jumper is set, the signal at the PCI Express Bus X2 pin B24 is
static High 3,3 V (with pull-up).
Compare section Pin Assignment for PCI Express Bus CIFX 100EH-
RE\CUBE on page 235.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011