cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 105/274
5.8.2 Device Drawing CIFX 104C-RE-R
Note:
Note:
Device supports Auto Crossover Function
With loaded EtherCAT Master firmware only RJ-45 channel 0 can be used, channel 1 is deactivated. For
Open Modbus/TCP with V2.3.4.0 and higher both channels can be used.
Figure 22: Device Drawing CIFX 104C-RE-R
The meaning of the LEDs displayed in Figure 22 depends from the loaded
firmware. See chapter LED Descriptions beginning from page 200.
Further refer to Device Connections and Switches page 215:
For the SYNC pin assignment of the SYNC Connector displayed in Figure
22 refer to section Pin Assignment SYNC Connector, X51 on page 228.
Note: The Mini-B USB Connector displayed in Figure 22 can only be
used for future hardware revisions. For further information refer to section
Mini-B USB Connector (5 Pin) on page 221.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011