cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 126/274
5.11 cifX Communication Interface PC/104
5.11.1 Device Drawing CIFX 104-RE
Note:
Note:
Device supports Auto Crossover Function
With loaded EtherCAT Master firmware only RJ-45 channel 0 can be used, channel 1 is deactivated. For
Open Modbus/TCP with V2.3.4.0 and higher both channels can be used.
Figure 35: Device Drawing CIFX 104-RE
The meaning of the LEDs displayed in Figure 35 depends from the loaded
firmware. See chapter LED Descriptions beginning from page 200.
Further refer to Device Connections and Switches page 215:
For the pin assignment of the PCI/104 bus X1/X2 displayed in Figure 35
refer to section Pin Assignment for PC/104 Bus on page 236.
For the SYNC pin assignment of the SYNC Connector displayed in Figure
35 refer to section Pin Assignment SYNC Connector, X51 on page 228.
For further information on the Mini-B USB Connector displayed in Figure
35 refer to section Mini-B USB Connector (5 Pin) on page 221.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011