cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 80/274
7. Connect the PC or the connecting device to the power supply and
switch it on.
‣ Connect the PC or the connecting device to the power supply.
‣ Switch on the PC or the connecting device.
5.5.4 Deinstalling CIFX 80-RE
To deinstall the CIFX 80-RE Communication Interface Compact PCI handle
as follows:
1. Take safety precautions.
Lethal Electrical Shock caused by parts with more than 50V!
• Disconnect the power plug of the PC or of the connecting device.
• Make sure, that the power supply is off at the PC or at the connecting
device.
2. Remove the connecting cable to the Master or Slave.
‣ Remove the connecting cable between the CIFX 80-RE Communication
Interface to be replaced and the PC card Real-Time Ethernet Master or
Slave.
3. Open cabinet.
‣ Open the cabinet of the PC or of the connecting device.
4. Deinstall CIFX 80-RE Communication Interface.
‣ Unscrew the CIFX 80-RE.
‣ First press the grey button at the ejection lever.
‣ Then press the ejection lever downwards.
‣ Remove the CIFX 80-RE from the compact PCI slot.
‣ Possibly reinsert a blank plate.
After this:
5. Close cabinet.
‣ Close the cabinet of the PC or connecting device.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011