cifX Communication Interfaces Real-Time Ethernet - Hilscher

Descriptions and Requirements 49/274
3.3.6 Requirements DMA Mode
cifX
In order to operate the cifX Communication Interface s in DMA Mode the
requirements given in the subsequent table must be met:
CIFX 50-RE,
CIFX 80-RE,
CIFX 90-RE\F,
CIFX 104C-RE,
CIFX 104C-RE-R,
CIFX 104C-RE\F,
CIFX 104C-RE-R\F,
CIFX 50E-RE,
CIFX 100EH-RE\CUBE
From
Hardware
Revision
1
4
1
Firmware File
Real-Time Ethernet
System
From Firmware
Version
CIFXECM.NXF EtherCAT Master 2.4.6.0
CIFXECS.NXF EtherCAT Slave 2.5.5.0
CIFXEIM.NXF EtherNet/IP Scanner 2.2.x.x
CIFXEIS.NXF EtherNet/IP Adapter 2.3.x.x
CIFXOMB.NXF Open-Modbus/TCP
CIFXPLS.NXF
POWERLINK Controlled
Node
For future
application only.
For future
application only.
CIFXPNM.NXF PROFINET IO Controller 2.3.x.x
CIFXPNS.NXF PROFINET IO Device 3.4.x.x (V3)
CIFXS3M.NXF SERCOS III Master For future
application only.
CIFXS3S.NXF SERCOS III Slave For future
application only.
CIFX 90E-RE\F No DMA - - -
Table 27: Requirements DMA Mode: Hardware and Firmware
Driver and Software
Version
or higher
cifX Device Driver cifX Device Driver Setup.exe 0.95x
SYCON.net SYCONnet netX setup.exe V1.201.x.x
Table 28: Requirements DMA Mode: Driver and Software
For further information on the question DMA Mode refer to the sections:
- References for Slot Number (Card ID) (page 19),
- The Function „DMA Mode“ (page 40),
- Activating DMA Mode in the cifX Device Driver Setup (page 196).
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011