cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 119/274
5.9.5 Replacing CIFX 104C-RE\F and CIFX 104C-RE-R\F
To replace the
• CIFX 104C-RE\F Communication Interface PCI 104(„\F“) and
• CIFX 104C-RE-R\F Communication Interface PCI 104(„\F“)
handle as follows:
1. Set the physical PCI 104 Slot Number.
‣ Set the physical PCI 104 Slot Number for the replacement CIFX 104C-
RE\F using the Rotary Switch for PCI 104 Slot Number on the
replacement CIFX 104C-RE\F.
Note: The module plugged next to the host controller gets the CLK
number 0, the following modules respectively get the next higher CLK
number. For further information refer to section Rotary Switch for PCI 104
Slot Number on page 222.
2. Take safety precautions.
Lethal Electrical Shock caused by parts with more than 50V!
• Disconnect the power plug of the PC or of the connecting device.
• Make sure, that the power supply is off at the PC or at the connecting
device.
3. Remove the connecting cable to the Master or Slave.
‣ Remove the connecting cable between the CIFX 104C-RE\F
Communication Interface to be replaced and the PC card Real-Time
Ethernet Master or Slave.
4. Open cabinet.
‣ Open the cabinet of the PC or of the connecting device.
For more see next page.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011