cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 71/274
5.4.4 Fix Front Plate Sticker at CIFX 50-RE and CIFX 50E-RE
Note: Your cifX Communication Interface set contains a set of front plate
stickers (6 different stickers). Depending from the loaded firmware the
label on each sticker indicates for the respective system the following LED
names:
- of the system and communication status LEDs (above)
- of the RJ45 Ethernet female connector LEDs (below).
Further information to this question you find also in chapter LED
Descriptions beginning from page 200.
Front Plate Stickers for CIFX 50-RE and CIFX 50E-RE:
Figure 6: Front Plate Stickers for CIFX 50-RE and CIFX 50E-RE to label the LEDs (6
different stickers)
LED
EtherCAT
Master
EtherCAT
Slave
EtherNet/IP
Open
Modbus/TCP
Powerlink
PROFINET IO
SERCOS III
SYS (yellow/green) SYS SYS SYS SYS SYS SYS SYS
COM 0 (red/ green) RUN RUN MS RUN BS SF STA
COM 1 (red/ green) ERR ERR NS ERR BE BF ERR
RJ45Ch0 green LINK L/A IN LINK LINK L/A LINK L/A
yellow ACT - ACT ACT - RX/TX -
RJ45Ch1 green - L/A OUT LINK LINK L/A LINK L/A
yellow - - ACT ACT - RX/TX -
Table 40: LED Labeling depending of the loaded Firmware
‣ Use the sticker according to the firmware and glue it on the front of the
CIFX 50-RE or CIFX 50E-RE Communication Interface.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011