cifX Communication Interfaces Real-Time Ethernet - Hilscher

Descriptions and Requirements 48/274
3.3.5 Requirements Slot Number (Card ID)
cifX
CIFX 50-RE,
CIFX 50E-RE,
CIFX 100EH-RE\CUBE
The requirements given in the subsequent table must be met in order to:
• a cifX Communication Interface is identified explicitly by the cifX Device
Driver via its Slot Number (Card ID) and can be distinguished from other
cifX Communication Interfaces in the PC.
From
Hardware
Revision
3,
4,
1
Firmware File
Real-Time Ethernet
System
From
Firmware
Version
CIFXECM.NXF EtherCAT Master 2.4.3.x
CIFXECS.NXF EtherCAT Slave 2.5.5.x
CIFXEIM.NXF EtherNet/IP Scanner 2.2.1.x
CIFXEIS.NXF EtherNet/IP Adapter 2.3.29.x
CIFXOMB.NXF Open-Modbus/TCP 2.3.3.0
CIFXPLS.NXF POWERLINK Controlled 2.1.19.x
Node
CIFXPNM.NXF PROFINET IO Controller 2.3.x.x
CIFXPNS.NXF PROFINET IO Device 3.3.6.x (V3)
CIFXS3M.NXF SERCOS III Master 2.0.9.0
CIFXS3S.NXF SERCOS III Slave 3.0.8.0
Table 25: Requirements Slot Number (Card ID):Hardware and Firmware
Driver and Software
Version
or higher
cifX Device Driver cifX Device Driver Setup.exe 0.95x
Bootloader (is included in the cifX Device Driver Setup)
V1.3.x.x
SYCON.net SYCONnet netX setup.exe V1.201.x.x
Table 26: Requirements Slot Number (Card ID): Driver and Software
For further information on the question Slot Number (Card ID) refer to the
sections:
- References for Slot Number (Card ID) (page 19),
- The Function „Slot Number (Card ID)“ (page 40),
- Rotary Switch for Slot Number (Card ID) (page 223),
- PCI and PCI Express: Setting Slot Number (Card ID) (page 67),
- Slot Number (Card ID) in the cifX Device Driver Setup (page 194)
- Slot Number (Card ID) in the Configuration Software (page 197).
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011