cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 69/274
5.4.2 Device Drawings CIFX 50E-RE
Note:
Device supports
Auto Crossover
Function
Note:
With loaded
EtherCAT
Master firmware
only RJ-45
channel 0 can
be used,
channel 1 is
deactivated.
For Open
Modbus/TCP
with V2.3.4.0
and higher both
channels can be
used.
Figure 4: Device Drawing CIFX 50E-RE (hardware revision 4, with Rotary Switch Slot
Number (Card ID))
Figure 5: Device Drawing CIFX 50E-RE (up to hardware revision 3)
Note:
Device supports
Auto Crossover
Function
Note:
With loaded
EtherCAT
Master firmware
only RJ-45
channel 0 can
be used,
channel 1 is
deactivated.
For Open
Modbus/TCP
with V2.3.4.0
and higher both
channels can be
used.
The meaning of the LEDs displayed in Figure 4 and Figure 5 depends
from the loaded firmware. See chapter LED Descriptions beginning from
page 200.
Further refer to Device Connections and Switches page 215:
For the SYNC pin assignment of the SYNC Connector displayed in Figure
4 and Figure 5 refer to section Pin Assignment SYNC Connector, X51 on
page 228.
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011