cifX Communication Interfaces Real-Time Ethernet - Hilscher

Hardware Installation, Deinstallation and Replacement 67/274
5.3 PCI and PCI Express: Setting Slot Number (Card ID)
Only for: CIFX 50-RE, CIFX 50E-RE and CIFX 100EH-RE\CUBE.
The Slot Number (Card ID) needs to be set at the cifX Communication
Interface using the Rotary Switch Slot Number (Card ID).
Device revisions equipped with a Rotary Switch Slot Number (Card ID)
are listed separately in section Hardware: cifX Communication Interfaces
Real-Time Ethernet on page 17 in Table 2.
Setting Slot Number (Card ID):
‣ Set the value 0 or a value from 1 to 9.
Switch
Meaning
Position
0 The value 0 means:
• no Slot Number (Card ID), i. e. the Slot Number (Card ID) is not
used,
• for downwards compatibility purposes,
• characterizes cifX Communication Interfaces not equipped with a
Rotary Switch Slot Number (Card ID);
i. e. these cifX Communication Interfaces are identified via its device
and serial number.
1 … 9 corresponds to the Slot Number (Card ID) 1 … 9
Table 37: Rotary Switch for Slot Number (Card ID)
The figure below shows the Rotary Switch Slot Number (Card ID) in
switch position 0 and 1.
Rotary Switch Slot
Number (Card ID)
Description
Rotary Switch Slot Number (Card ID) Switch Position 0
Rotary Switch Slot Number (Card ID) Switch Position 1
Table 38: Switch Position Rotary Switch Slot Number (Card ID)
For further information about the Slot Number (Card ID) refer to the
sections:
- References for Slot Number (Card ID) (page 19),
- The Function „Slot Number (Card ID)“ (page 40),
- Requirements Slot Number (Card ID) (page 48),
- Rotary Switch for Slot Number (Card ID) (page 223),
- Slot Number (Card ID) in the cifX Device Driver Setup (page 194)
- Slot Number (Card ID) in the Configuration Software (page 197).
cifX Communication Interfaces Ethernet | Installation, Operation and Hardware Description
DOC060501UM30EN | Revision 30 | English | 2011-06 | Released | Public © Hilscher, 2006-2011